Crafter's Companion Gemini JUNIOR Mode D'emploi page 6

• Start with the Clear Cutting Plate on the bottom.
• Place the Plastic Shim on top.
• Place the Magnetic Shim on top of the Plastic Shim, magnet side up.
• Position the die, blade side up, with the smooth side facing the Magnetic Shim.
• Place your Material on top of the die.
• Place the Metal Cutting Plate on top of the Material to be cut.
• Place the Clear Cutting Plate on top of the Metal Cutting Plate.
• Align the platform combination and feed it into the Gemini Jr.™.
• Release your hold on the platform combination once the motor begins to pull it
into the machine.
DEEP MULTI MEDIA DIES
Deep multi media dies are manufactured deeper than traditional thin metal dies,
which allow you to cut a variety of different materials for your multi media projects.
Because they're a little deeper you will need to alter the plate configuration to
accommodate for this.
Recommended Combination: Clear Cutting Plate on the bottom, then the Plastic
Shim, Multi Media Die, Material to be cut, and Clear Cutting Plate on top.
• Start with the Clear Cutting Plate on the bottom.
• Place the Plastic Shim on top of it.
• Position the cutting die, blade side up, with the smooth side facing the Plastic
Shim.
• Place your Material on top of the die (up to 6 pieces of thin fabric).
• Place the Clear Cutting Plate on top of the Material to be cut.
• Align the platform combination and feed it into the Gemini Jr.™.
• Release your hold on the platform combination once the motor begins to pull it
into the machine.
NOTE: The illustration above shows 6 layers of thin cotton fabric – Deep multi media dies
will cut a variety of different materials, however we recommend that the total thickness
of the material you are cutting should be no more than 2mm. Performance of the die and
machine will differ depending on the density of the material, take care when trying new
materials.
Pg.4 | ENG-4
Clear Cutting Plate
Material to be cut
Die (blade side up)
Plastic Shim
Clear Cutting Plate