Discharge Chute Assembly; Starting The Machine - SNOWJOE iON18SB Manuel D'utilisation

Fig. 8

Discharge Chute Assembly

1. Lift the chute deflector until it locks securely into place on
the discharge chute.
2. Raise or lower the chute deflector to the desired height of
the snow stream.
3. Insert the washers into the middle of the chute
connection, pass the carriage bolts through from the
inside of the chute, and tighten with the deflector knobs
on each side (Figs. 9 & 10).
NOTE: Do not overtighten the knobs.
Fig. 9
Chute deflector
Washers
Fig. 10
Handle knob
Square
J-bolts
Operation
m
WARNING!
toys or other foreign objects that the rotor blades might pick
up and throw. Such items could be covered by snow and are
easy to overlook, so be sure to conduct a thorough inspection
of the area before beginning work.
NOTE: Before using this machine, make sure that the snow
blower's roll shaft and rubber plates are firmly secured with
screws, and that the rubber plates are facing the correct
direction. Perform a test run to ensure that the rotor turns
freely.

Starting the Machine

1. Open the battery compartment cover and slide the battery
down until it clicks to lock it into position (Fig. 11).
Fig. 11
11
Deflector knob
Carriage bolt
Keep the area to be cleared free of stones,
Battery