Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Product overview
1.
Front fan guard
2.
Fan blade
3.
Mounting nut
4.
Rear fan guard
5.
Motor shaft
6.
Motor housing
7.
Oscillating knob
8.
Neck
9.
Base
10.
Speed switch (0,1,2)
Product assembly
•
Loosen the mounting nut from the motor housing.
•
Place the rear fan guard securely against the motor housing and tighten
the mounting nut by turning it clockwise.
•
Push the fan blade over the motor shaft.
Place the front fan guard against the rear fan guard, ensuring that the
fan guards are locked in the ring. Then secure the fan guards with the
clamps.
• The fan guards must be fixed by means of the screws supplied.
• Press the oscillating knob to activate the oscillation function.
• Pull the oscillating knob upwards to disable the function.
OPERATION OF THE DESK FAN
ATTENTION:
•
Choose a suitable location for the fan. Always choose a location that
meets the safety requirements stated in this manual.
•
When placing the fan on a table or board, always check that the cord
cannot be pulled accidentally or that the appliance can fall over.
•
Never hang the fan on a wall or ceiling.
1. Switch on / off and control speed
The device can be switched on and off and the speed can be controlled
by means of the speed switch. You can choose from the following
modes:
0
The fan is off
1
The fan is at a low setting
2
The fan is at a high setting
2. Adjust angle direction
Publicité
Table des Matières
