Operation - Domair TX-1608B Manuel D'utilisation

FOOT MOUNTING
1- Assemble the two legs of the
base.
2- Assemble the outer tube to
the base: screw it in, making sure that
the 4 screws are tight.
3- Fit the plastic cover on the
outer tube.
4- Set up the 4 feet as shown in
the drawing at the beginning of the
paragraph.
MOUNTING THE HEAD ON THE
FOOT

Operation

1. Before using this appliance, place it
on a stable, dry surface.
2. Insert the power plug into a wall
outlet.
3. Press one of the buttons (1, 2 or 3)
to select the desired speed.
Tilt
1. For your safety, make sure the fan is
in the off position before tilting the grille.
Oscillation
Oscillation is started by the oscillation
button located on the top of the power
unit.
REV 1 – 26 08 19 Fabriqué en Chine
Unscrew the height adjustment knob
at the top of the outer tube. Pull up the
inner tube, adjust the height and
tighten the knob firmly.
Insert the fan head onto the inner tube
and secure it by firmly tightening the
retaining screw on the back and
bottom of the command unit.
The air control speeds are as follows:
1- Low Speed
2- Medium Speed
3- High Speed
4. Press 0 to stop the appliance
2. Using the handle on the rear grille,
gently pull the grille up or down at the
desired angle.
Press the control knob to engage the
oscillation. Ensure
that the grilles do not touch anything
during the oscillation.
Pull on the control knob to stop the
oscillation.
Page 30