Cleaning And Storage; Troubleshooting - OEM FHTG-205B Mode D'emploi

Cleaning and Storage

PLEASE NOTE!
■ DANGER – Risk of Electric Shock! The device must always be disconnected from
the mains power before it is cleaned.
■ The device is not dishwasher-safe.
■ Never spray cold water onto the plates during or immediately after use of the device.
This could damage the non-stick coating!
■ Do not use any corrosive or abrasive cleaning agents, cleaning sprays, rough
sponges or knives to clean the device. These may damage the surface.
Clean the device immediately after every use to prevent the formation of germs. Do not
allow any food residues to dry on.
1. Make sure that the device has completely cooled down and has been disconnected
from the mains power!
2. Remove any food residues from the grill plates (1, 8).
3. Pull the fat collecting tray (5) out of the bottom part of the housing, empty it and clean
it with a little detergent and warm water or in the dishwasher.
4. Clean the grill plates with a wet sponge and a little mild detergent.
5. Wipe down the housing with a damp cloth.
6. Then dry off the device with a soft cloth.
7. Store the device in a dry, clean, frost-free place that is not accessible to children and
animals.

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the
problem yourself. If the problem cannot be solved with the steps that are listed, contact
our customer service department.
Do not attempt to repair an electrical device yourself!
Problem
The device does not
work. The operating
lamp (4) does not
light up.
The fuse in the fuse
box is triggered.
The heating control
lamp (2) is not lit.
05666_DE-EN-FR-NL_A5_V1.indb 17 05666_DE-EN-FR-NL_A5_V1.indb 17
17
Possible cause
The mains plug is not in-
serted correctly in the plug
socket.
The plug socket is defective.
There is no mains voltage.
Too many devices connected
to the same circuit.
The device has not yet
reached operating tempera-
ture.
Fix
Plug in the mains plug.
Try another plug socket.
Check the fuse of the mains
connection.
Reduce the number of
devices in the circuit.
Wait until the device has
heated up suffi ciently.
30.08.2019 13:32:09 30.08.2019 13:32:09
EN