Connection - JVC KD-DB95BT Manuel D'instructions

Wiring connection
KD-DB95BT KD-DB65
Front output
Rear/subwoofer output
Antenna input terminal
(for FM/AM)
To the steering wheel
remote control adapter
For some VW/Audi or Opel (Vauxhall)
automobiles
You may need to modify the wiring of the
supplied power cord (D) as illustrated.
If the unit does not turn on with modified
wiring 1, use modified wiring 2 instead.
Y: Yellow R: Red
Original wiring
Modified wiring 1
( or )
Modified wiring 2
Rear/subwoofer output
DAB antenna jack (SMB connector)
Light blue/yellow
STEERING
WHEEL
REMOTE
If your car does NOT have an ISO
terminal
* Custom wiring harness (separately
purchased)
IMPORTANT: A custom wiring harness
(separately purchased) which is suitable for
your car is recommended for connection.
Remote wire
Signal cord
(not supplied)
(not supplied)
JVC Amplifier
Fuse (10 A)
ISO connector
Pin Color and function
A2 * Brown
A4 Yellow
A5 Blue/White
A6 Orange/white
A7 Red
A8 Black
B1 Purple
B2 Purple/black
B3 Gray
B4 Gray/black
B5 White
B6 White/black
B7 Green
B8 Green/black
* For KD-DB65
Part list for installation
To Blue/white
wire of the wiring
(A) Faceplate
harness (D)
KD-DB95BT
MIC (Microphone input
terminal) ( 11)
(B) Trim plate
(C) Mounting sleeve
: Tel muting
: Battery
: Power control
: Car light control switch
(D) Wiring harness
: Ignition (ACC)
: Earth (ground) connection
: Rear speaker (right)
: Front speaker (right)
(E) Extraction key
: Front speaker (left)
: Rear speaker (left)
ENGLISH | 23