Beta 3063/2,5T Mode D'emploi page 8

INSTRUCTIONS FOR USE
EN
PACKAGING
- The body, the handle and the other parts of the jack are packaged in a three-ply corrugated carton with pallet; the
RSHUDWLQJ DQG PDLQWHQDQFH PDQXDO DQG WKH ZDUUDQW\ FHUWL¿FDWH ZLOO EH IRXQG LQ D IROGHU LQ WKH ER[
- The instruction "Keep upright" is clearly visible on the carton containing the jack.
- Pallets of different sizes are used, depending on the number of jacks shipped.
- Either transpallets or forklifts are used to handle the packaging.
STARTING
ASSEMBLY
1. Take the handle and the jack from the carton.
2. Loosen both nuts from inside the chassis.
3.Loosen screw from the chassis and remove parts, keeping them assembled.
)LW WKH FRXSOLQJ RI WKH KDQGOH LQWR WKH JURRYH ¿W WKH SUHYLRXVO\ UHPRYHG SDUWV LQWR WKH KROH RI WKH KDQGOH 7LJKWHQ
screw with nut
5.Connect the two air pipes that come out of the handle into the quick couplings in the chassis according to the
colour indication of the sticker on the chassis. DWG. 10
CONNECTION TO COMPRESSED AIR SYSTEM
- Compressed air enters the jack circuit through the quick coupling on top of the manual jack lifting/lowering control;
a connecting pipe with a quick coupling compatible with that of the jack is therefore required.
Check that the air supply pipe has a useful passage of at least 6 mm and that it is not pinched or restricted anywhe-
re. DWG. 11
$LU VXSSO\ SUHVVXUH    %$5
 1HYHU OHW K\GUDXOLF RU YDVHOLQH RLO EUDNH ÀXLG SDUDI¿Q RU DQ\ RWKHU OLTXLGV LQWR WKH FRPSUHVVHG DLU FLUFXLW
 ,QVWDOO D ¿OWHU GHKXPLGL¿HUOXEULFDWRU XQLW LQ WKH FRPSUHVVHG DLU V\VWHP
- To lubricate the compressed air circuit, use only:
AGIP OSO 100; MOBIL DTE 27; ESSO TERESSO 100;
SHELL TELLUS 100; BP ENERGOL HP 100
8