Checking Oil Level; Technical Data Sheet - Beta 3063/2,5T Mode D'emploi

INSTRUCTIONS FOR USE

CHECKING OIL LEVEL

,03257$17( The jack can contain up to 500 ml of oil.
6LQFH WKH MDFN LV ¿WWHG ZLWK D FORVHG K\GUDXOLF FLUFXLW DV D UXOH WKH RLO OHYHO GRHV QRW KDYH WR EH FKHFNHG +RZHYHU
in the long run, if the gaskets are worn or if there are any leaks, it might be necessary to check and restore the oil
level. For this procedure to be performed, the power unit must be removed from the jack. Check the oil level as
follows:
1.Remove the power unit (see "Removing power unit A03843").
2.Place the power unit and keep it upright.
3.Remove oil cap A – DRW. 12 after cleaning the area near it, and making sure that no contaminants are let into
the circuit.
4.Measure the oil level by inserting a clean dipstick, to avoid contaminating the oil. (DWG. 12)
5.The oil level range should be 55 mm ±5 mm (2.2 in ±0.2 in).
7R DGG RLO GLVFRQQHFW WKH SLSH IURP ¿WWLQJ B – DWG. 12.
7.When the procedure has been completed, screw cap A back in place – DWG. 12.

TECHNICAL DATA SHEET

Working air pressure
Operating temperature
Air consumption
Tipi olio compatibili
Pneumatic system pipes
Aerial noise – Acoustic radiation pressure: 60 dBA
Tests performed in accordance with standards ISO/R 1680 - 1970 Instrument: LARSON DAVIS 800B PRECISION
SOUND LEVEL METER compliant with standards IEC 804 E 651 class 1 set with a Larson Davis Ca 250 114/b
250 Hz calibrator, before and after measurements.
10
8 > 10 bar 116 > 145 psi
-20°C > +50°C -4°F > 122°F
400 nl/min
ATF Dexron IID
Rilsan ø 6x4 mm
Weight 60 Kg 132 lb
Max. stroke 585 mm
23 in
1st piston 2.5 t
capacity 3 ton (short)
2nd piston
capacity
3rd piston
capacity
4th piston
capacity
5th piston
capacity
EN
-
-
-