Saw Chain And Guide Bar; Accessories - Black & Decker BECS600 Mode D'emploi

English
Bucking

WARNING: Recommend that first time users should
practice cutting on a saw horse.
Cutting a felled tree or log into lengths. How you should
cut depends on how the log is supported. Use a saw horse
whenever possible as shown below.
1. Always start a cut with the saw chain running at
full speed.
2. Place the bottom spike
area of the initial cut as shown below.
3. Turn the chainsaw on then rotate the saw chain and bar
down into the tree, using the spike as a hinge.
4. Once the chainsaw gets to a 45° angle, level the
chainsaw again and repeat steps until you cut
fully through.
5. When the tree is supported along its entire length, make
a cut from the top (overbuck), but avoid cutting the earth
as this will dull your saw quickly.
21
• When supported at one end first, cut 1/3 the diameter
from the underside (underbuck). Then make the finishing
cut by overbucking to meet the first cut as shown below.
2
1
12
21 of the chainsaw behind the
CUT FROM TOP (OVERBUCK)
AVOID CUTTING EARTH
2nd CUT OVERBUCK
(2/3 DIAMETER)
TO MEET 1st CUT
(TO AVOID PINCHING)
1st CUT UNDERBUCK
(1/3 DIAMETER)
AVOID SPLINTERING
• When supported at both ends. First, cut 1/3 down from the
top overbuck. Then make the finished cut by underbucking
the lower 2/3 to meet the first cut as shown below.
• When on a slope always stand on the uphill side of
the log. When "cutting through", to maintain complete
control reduce the cutting pressure near the end of the
cut without relaxing your grip on the chain saw handles.
Don't let the chain contact the ground. After completing
the cut, wait for the saw chain to stop before you move
the chain saw. Always stop the motor before moving
from cut to cut.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start‑up can cause injury.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non‑metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.

Saw Chain and Guide Bar

After every few hours of use, remove the sprocket cover,
guide bar and chain and clean thoroughly using a soft bristle
brush. Ensure oiling hole on bar is clear of debris. When
replacing dull chains with sharp chains it is good practice to
flip the chain bar from bottom to top.

Accessories


WARNING: Since accessories, other than those
offered by BLACK+DECKER, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be
used with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service
center. If you need assistance in locating any accessory, please
contact BLACK+DECKER call 1-800-544-6986 .
1st CUT OVERBUCK
(1/3 DIAMETER)
TO AVOID SPLINTERING
2nd CUT UNDERBUCK
(2/3 DIAMETER)
TO MEET 1st CUT
(TO AVOID PINCHING)