KeySonic ACK-126 RF Mode D'emploi page 8

1.3 Keyboard installation
• Recommended requirement for that is the successful installation
of the USB receiver under point 1.2
• Remove on the „OPEN" symbol the silicone cover of the battery
case on top side of your keyboard. Install the both included
batteries of type AAA-1.5 V considering the right polarity in the
battery case (see picture).
• The USB receiver and the keyboard are factory-made already
synchronised on the same channel. Normally you have not to
make a new-synchronisation (as described under point 1.4).
• You can check this by pressing any key of your keyboard. If you
press the Windows key, there has to open for instance the
Windows Pop-up menu down left on your screen. If so, your
wireless keyboard is working correctly now. If not, please
synchronise the USB receiver and the keyboard again like
described under point 1.4.
1.4 New-synchronisation of the radio channel
• When you start up your keyboard for the first time and
no connection could be established, so synchronise
the radio channel between keyboard and USB receiver
again by pressing firstly the „CONNECT" key on the
USB receiver. The LED in the USB receiver starts
blinking and signalises therewith, that it is waiting on
synchronisation-signal of the keyboard.
• Press now during the next 15 seconds the „CONNECT" key on backside of your
keyboard. The keyboard sends with it the synchronisation signal to USB receiver.
After successful synchronisation the blinking LED of the USB receiver turns to
continuous lighting.
The keyboard is ready for use now. Check it as described under point 1.3.
Advise: Should the „CONNECT" key on your keyboard not be pressed within 15 seconds, so the blinking
LED turns to continuous lighting without previous synchronisation.
Is your keyboard after new-synchronisation still not working, you have the following possibilities to solve the
problem:
• Repeat the procedure of synchronisation as described under 1.4. Sometimes it is necessary to repeat this
routine several times, until the right radio channel was found.
• In case your USB receiver is attached to an USB hub, you should install it directly on the USB connector
of your notebook or desktop.
•
During the procedure of synchronisation the keyboard should be located close to the USB receiver to
make sure, that the immediate environment has no influence on the radio transmission (for instance
reduction/ interferences due to metal cases, other sources of interferences etc.).
•
Ensure that you use only batteries with full loading capacity. In case of doubt change the old batteries
before next synchronisation against new ones as a precaution.
CONNECT key
- 6 -
Operation Manual
LED
E&OE