RiverRidge 06-187 Instructions D'assemblage page 8

STEP 1
1. Place top board (1) upside down on soft padded surface.
2. Attach back cross bar (4) to top board (1) by inserting 2 screws (B) through holes on back
cross bar (4), then tighten to top board (1).
3. Repeat above step to attach front cross bar (5) to top board (1).
STEP 2
1. Attach top board (1) to side frame (2) by inserting 2 screws (A) through holes on side
frame (2), then tighten to back cross bar (4) and front cross bar (5) by using Allen wrench
(F). When tightening, slightly push screw in to catch inner thread.
2. Attach 1 shelf (3) to side frame (2) by inserting 2 screws (A) through holes on side frame
(2), then tighten to shelf (3) using Allen wrench (F).
3. Repeat above step to assemble other 2 shelves (3).