Spare Part Order - Zipper ZI-FKS315 Mode D'emploi

Maintenance
2.8
No cleaning, upkeep, checks or main-
tenance when machine is running
Be safe: Shut off the machine, disconnect
it from the power supply.
The machine does not require intense mainten-
ance. However, to ensure a long lifespan, we
strongly recommend following the upkeep and
maintenance plan.
Repairs must be carried out by specialists! Use
original ZIPPER parts only!
2.8.1 Changing the saw blade (Fig.
16)
Set the maximum cutting depth (see 2.6.1).
Remove the blade guard (see 2.5.2) and the
sliding table (see 2.5.3). Then open the chip
box (see 2.5.3). Use the two included tools 40,
41 to loosen the screw 42. Change the blades.
Important: Clean the flange before fitting the
new blade.
Important: Note the running direction! The
cutting angle of the teeth must point in running
direction (see the arrow on the chip box). Do
these steps backwards for fitting the new saw
blade.
2.8.2 Upkeep and maintenance plan
Loose or lost screws, nuts,
bolts
Damage of any part of the
machine
Machine cleaning
2.8.3 Cleaning
Clean the machine from dirt, chippings, etc ...
Clean the machine housing with a wet cloth
and a mild cleaning solution.
A C H T U N G
Regularly prior to
each operation
Regularly prior to
each operation
Regularly after op-
eration
I M P O R T A N T
The usage of solvents, aggressive
chemicals
damages the machine housing.
2.8.4 Disposal
DO NOT dispose your ZI-FKS315 in the residual
waste! Contact your local authorities for in-
formation about best available disposal possib-
ilities in your area. Drain fuel from the fuel
tank completely before disposing the earth
auger. Disaggregate the auger into its compon-
ents before disposing its compo.
Storage
2.8.5
Always store your machine in clean, dry rooms
and cover it with a tuck. Fort he transport you
have to use the wheels (see 2.8.6).
Using the chassis (Fig. 11)
2.8.6
To swing the chassis out, gently lift the saw at
the back and push the wheels backwards 15.
Then lower the saw. It is now standing on the
wheels and can be transported by one person
with the aid of the handles 16 easily.
Important: Never lift the saw by the sliding
table!
Important: After the transport the chassis
must be retracted in order to ensure that the
saw is standing securely. To do this, return the
wheels to their starting position by following
the sequence in reverse.

Spare part order

2.9
With original ZIPPER spare parts you use parts
that are attuned to each other and shorten the in-
stallation time and
lifespan.
I M P O R T A N T
The installation of non-original parts renders
warranty null and void.
Exempted is the replacement of the spark plug if
carried out by a specialist.
Send your spare part list inquiry to the reseller you
acquired the machine from or to the ZIPPER Custom-
er Service.
You find the order address in the beginning of this
operation manual.
or scouring agents
elongate your machines