Diamond PSR 400 GE Notice D'utilisation Et D'installation page 5

Instructions manual
PSR 400 GE PSR 600 GE PSR 900 GE
Congratulations for purchasing this top professional equipment. You have chosen equipment
that combines optimum technical properties with extreme user comfort. We want you to get
the greatest possible satisfaction out of this equipment.
I SAFETY INSTRUCTIONS
Please comply closely with these instructions to avoid any risk of fire, burns or other injures
or damage.
When using this equipment, comply constantly with the basic safety precautions, for
instance:
- Take into considerations the instructions, keeping them with the equipment at all
times.
- Always install the equipment in compliance with the instructions.
- Protect the equipment from sunlight, freezing and damp.
- Do not leave the equipment within reach of children.
- Make sure that only trained people use the equipment.
- Never move of the equipment when it is operating, or when the surfaces are still
hot.
- Never use equipment for other purposes than intended.
- Never touch the hot surfaces: use the handles and buttons.
- Confine repairs to qualified personnel only.
- Use only original spare parts.
II CONTAINT OF PACKING CARTON
- Equipement : Griddle plate
III CONFORMITY OF USE
Use the equipment exclusively to grill steaks, bacon, hamburgers, fish, sausages, vegetable
and also to fry eggs and omelettes.
IV OPERATING MODE
This griddle plate is fitted with enamelled cooking plate.
The heating of the griddle is made thanks to burners witch allowed a homogenous
temperature.
Lighting:
- Press the knob in for a few seconds.
- Press the piezo to light on the burner
- Keep the knob pressed in for a few more seconds.
- The burner remains lit and now you can adjust the appliance to the setting required.
A thermocouple cuts off the gas supply if one of the burners goes out. The appliance has a
factory-adjusted low flame setting.
This appliance is fitted with a completely removable drip tray for juice and grease.
Never use the appliance without any drip tray.
V OPERATION / HANDLING
a) Installation / Assembly:
- Place the equipment on a stable and heat resistant surface.
- Never place the appliance near to a wall or a partition made with combustible
materials even if it is covered with a good insulating material.
- A distance of 10 cm from the partition or the wall is considered enough.
- The identification plate is located on the back of the appliance.
b) Gas connection:
The appliances operate on the following gases: Butane G30, Propane G31, Gas natural
G20/G25 and at all pressures encountered on mains gas. The appliances are supplied from
the factory with a Butane/Propane injector corresponding to category II2E+3+.
The heat output of the appliance is:
Connect the appliance to the gas supply pipe, interposing a stop valve which enables the
appliance to be isolated from the rest of the installation. Connection is with a ½ thread.
Check that the settings correspond to the type and pressure of the gas distributed in the
installation.
Check the supply pressure with all the burners alight using a gas manometer
This should be the same as indicated on the identification plate.
PSR 400 GE 3.2 Kw
PSR 600 GE 6.4 Kw
PSR 900 GE 9.6 Kw