Siemens TJ10100 Mode D'emploi page 26

Pull the button band on the shirt down and
fit it vertically onto the button band adjuster,
Fig. 8.
To avoid marking of any kind, do not insert
the button band too much. Position the
button band in such a way that the
perforated plate is completely covered.
Starting at the top, close all the flaps on the
button band adjuster. Secure the button
band firmly in place. Close those flaps not
required to hold the shirt in place as well.
Repeat this proceeding to tighten the other
side of the shirt.
Turn the collar adjuster knob clockwise from
its vertical position while adapting the back
of the collar to the Ironer by pulling it gently
upwards with the other hand.
Close the two upper supports on the casing
to maintain the shirt collar up. Correct the
positioning of the back of the shirt by pulling
it lightly upwards.
A spring adapts the collar adjuster to the
size of the shirt collar. The rotated position
of the knob depends on the size of the
shirt.
Do not overturn the knob when turning it
clockwise. The knob sets itself in the right
position.
Do not adjust the knob when the appliance
is inflated.
Long-sleeved shirts
Pull on the cuff adjusters until the arms of
the ironing dummy reach their maximum
length (longer than the shirtsleeves).Raise
the shirt to make sure that the ironing
dummy arms are not twisted.
After pulling the shirtsleeves back down,
push the ironing dummy arms back into the
shirtsleeves from the cuff adjusters until the
seams between the cuffs and the sleeves
line up with the curved parts of the cuff
adjusters, Fig. 9.
Warning!
Make sure that the ironing dummy arms
are not twisted inside the shirtsleeves.
Open the flaps on the cuff adjusters.
Use
Position the shirt cuffs on the cuff adjusters.
Make sure that the cuff adjusters are
aligned beneath the openings where the
two sides of the shirt cuffs join.
Close the flaps. The cuff adjusters hold the
shirt cuffs firmly in position.
Short sleeves:
Fit button arm straps onto the ironing
dummy arms approximately 5 cm beneath
the shirtsleeves. Figs. 10 and 11.
Warning!
Only use the button arm straps supplied by
the manufacturer. Only these straps
guarantee the air pressure required for
good ironing results.
Adjusting size
If necessary, adjust the size by gradually
loosening the adjustment cords.
Attention:
Please make sure that both upper cords
that adjust the dressman to the individual
shirt sizes are never fully tightened.
To do so ensures that the internal air flow
is not interrupted and therefore assures a
perfect ironing result.
For an optimum ironing result please
always adjust all cords to the individual cut
and size of the shirt/blouse.
If the adjustment cords are too tight, the
ironing dummy can be adjusted to the
garment by gradually loosening the cords.
The adjustment cords not covered by the
shirt need to be adjusted.
Starting the ironing process
Press the
comes on.
Set the programme selector switch 4, Fig. 1
to the programme for the fabric to be
ironed. Remember that the temperature is
the same for all of the ironing cycles; drying
time is the only thing that varies.
None of the indicator lights light up. More
than 5 minutes have passed since the
ironing programme was selected and the
shirt ironer has turned itself off.
26
button. The indicator light