Samsung 5 Serie Mode D'emploi page 6

The TV may not output sound and pictures may be displayed with abnormal colour when DVD / Blu-ray player / Cable Boxes
N
/ Satellite receivers supporting HDMI versions older than 1.3 are connected. When connecting an older HDMI cable and
there is no sound, connect the HDMI cable to the HDMI IN 1(DVI) jack and the audio cables to the PC / DVI AUDIO IN jacks
on the back of the TV. If this happens, contact the company that provided the DVD / Blu-ray player / Cable Box / Satellite
receiver to confirm the HDMI version, then request a firmware update. HDMI cables that are not 1.3 may cause annoying
flicker or no screen display.
8 COMPONENT IN
– Connect component video cables (optional) to component connector (P
to corresponding component video out connectors on the DTV or DVD.
– If you wish to connect both the Set-Top Box and DTV (or DVD), you should connect the Set-Top Box to the DTV (or DVD)
and connect the DTV (or DVD) to component connector (P
– The P , P and Y connectors on your component devices (DTV or DVD) are sometimes labelled Y, B-Y and R-Y or Y, Cb
R B
and Cr.
– Connect RCA audio cables (optional) to [R-AUDIO-L] on the rear of your set and the other ends to corresponding audio
out connectors on the DTV or DVD.
9 EXT (RGB)
Connector
Video
EXT O
– Inputs or outputs for external devices, such as VCR, DVD, video game device or video disc players.
0 SERVICE
– Connector for software upgrades.
! AV IN [VIDEO] / [R-AUDIO-L]
– Connect RCA cable to an appropriate external A/V device such as VCR, DVD or Camcorder.
Connect RCA audio cables to [R-AUDIO-L] on your set and the other ends to corresponding audio out connectors on the
–
A/V device.
@ COMMON INTERFACE Slot
•
When not inserting 'CI CARD' in some channels, 'Scrambled Signal' is displayed on the screen.
• The pairing information containing a telephone number, CI CARD ID, Host ID and other information will be displayed in
about 2~3 minutes. If an error message is displayed, please contact your service provider.
•
When the channel information configuration has finished, the message 'Updating Completed' is displayed, indicating that
the channel list is now updated.
You must obtain a CI CARD from a local cable service provider. Remove the CI CARD by carefully pulling it out with your
N
hands since dropping the CI CARD may cause damage to it.
N
Insert the CI-Card in the direction marked on it.
N
The place of the COMMON INTERFACE Slot may be different depending on its model.
N
CAM is not supported in some countries and regions, check with your authorized dealer.
N
Input
Audio (L / R) RGB
O O
English - 4
, P , Y) on the rear of your set and the other ends
R B
, P , Y) on your set.
R B
Output
Video + Audio (L / R)
Only TV or DTV output is available.