Pre-Installation; Installation And Mounting - Lutron LOS-C Serie Instructions D'installation

Pre-installation

WARNING: SHOCK HAZARD. May result in death or serious injury.
Disconnect power before servicing or installing.
1. For installation by a qualified electrician in accordance with national and local codes and the following instructions.
2. Use copper conductors only
3. Do not connect this product to line voltage/mains cable
4. For indoor use only.
5. Check to see that the device type and rating is suitable for the application.
6. Do not install if product or lens have any visible damage.
7. If moisture or condensation is evident, allow the product to dry completely before installation.

Installation and Mounting

Normal Mounting:
Insert ACAK into mounting bracket and twist
90˚ to lock in place. Drill through ceiling tile with
assembly,using the cutter end of the threaded
mounting post. Secure with washer and nut.
ACAK
Acoustic Ceiling
Adaptor Kit (optional)
Wiring Sensor:
Route wiring through ACAK/ceiling tile. Attach the sensor body
to the cover plate by aligning the arrows and twist locking into
place. Connect wiring with twist on connectors.
Wire Lengths (when powered by power pack)
Number of Sensors
Number of Auxiliary
Power Packs
22 AWG
0.5 mm 2
20 AWG
0.75 mm 2
18 AWG
Using the Infrared Mask
Center Ceiling Mount
(Mask blocks sensor
seeing out doorway
into hall)
Sensor Adjustments
Override Settings
Auto/Manual
Threshold
LED Motion Indicator
Reset Learned Settings
Strong Airflow Compensation
Over Doorway Installation
Timer Adjust
Auto Sensitivity
Cutter end
1 2 3
0 0 0
750 ft 375 ft 250 ft
365 m 180 m 120 m
1200 ft 600 ft 400 ft
730 m 365 m 240 m
2400 ft 1200 ft 800 ft
Corner Ceiling Mount
(No mask needed)
A
Off (Default)
Automatic (Normal)
1
2
Auto Threshold Adjustment
3
Lights indicate motion
4
Retain Settings (Normal)
OFF ON
B
Off (Default)
Disable Compensation (Normal)
1
No (Normal)
2
Adjust timer Automatically
3
4 Adjust Sensitivity Automatically
OFF ON
Mounting to Non-Standard Ceiling/Fixture:
Drill wiring routing hole and (2) mounting holes using
Mounting Bracket as template. Secure twist-lock
cover plate using mounting screws, nuts, and
washers (included).
1 2 1
1 1 2
375 ft 250 ft 250 ft
90 m 120 m 120 m
600 ft 400 ft 400 ft
365 m 240 m 365 m
1200 ft 800 ft 800 ft
Typical Mask Patterns
Conference
Room Mask
Rectangular
Areas
On
Manually On/Off (Override)
High Sensitivity (Low turn-on threshold)
Disable LED Indicator
Erase all learned settings; Restart Learning (Toggle On)
On
Enable Compensation
Yes (Use increased turn-on threshold)
Use Manual Setting
Adjust Sensitivity Manually
Mounting Plate Dimensions
0.52 in
(13.3 mm)
2.5 in
(63 mm)
180° Mask Full Mask
Over the Specific
Door Areas You
Wish to Mask
4.2 in
(106.6 mm)
®