Getting Started - Ribimex Ribiland PRDATA21 Manuel D'instructions Et D'utilisation

IV. GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that product and accessories are not damaged.
- Content: 1 hose reel (fitted with 1 main hose Ø ½" x 20m and 1 attached lead hose Ø ½" x
2m) ; 2 quick connectors; 1 tap connector; 1 spray nozzle; 1 wall bracket with pivot point; 1
screw kit (3 screws, 3 masonry plugs); 1 user manual.
4.2- Installation
WARNING: If not properly installed, there is a risk of falling. Make sure your installation
can support the loads.
WARNING: This hose reel is not recommended for ceiling-mount applications.
Choosing a location
This reel is best installed close to a source of water.
For a large area, please place it in the center of the work area and then you can extend the
hose to the most convenient point in this area.
The hose reel must be mounted on a strong surface, due to product's weight when full of
water and the pulling action during use.
We recommend to mount the bracket on a wall (concrete or brick) or timber (solid wood).
There are many alternative positions in which the unit can be placed.
The key point is subject to what is convenient for the user.
The most appropriate position is to mount the bracket on a wall or post horizontally, at
approximately 1~1.25m above ground level.
The mounting bracket has 3 holes, for each there is a corresponding screw.
Bracket installation on wall (see Fig.2a)
Use the provided drawing template to mark the 3 holes' position on your chosen location.
Drill the holes with 12mm drill bit at 50mm deep.
Insert the masonry plugs into the holes (use hammer if deemed necessary)
Insert screws into plugs and tighten accordingly.
Bracket installation on solid wood (see Fig.2b)
Use the provided drawing template to mark the 3 holes' position on your chosen location.
Drill the holes with 5mm drill bit at 60mm deep.
Insert screws into holes and tighten accordingly.
Setting the hose reel (see Fig.3)
Once the screws are installed, lift the reel and place the bracket in the screws.
Connect the quick connector of the lead hose to the tap (make sure your tap is fitted with tap
connector, not provided).
Connect the spray nozzle to the quick connector of the main hose.
You hose is set up and ready for use.