Automatic Channel Search; Initial Installation; Channel List; Use Of The Channel List - Grandin LD50V274 Mode D'emploi

Options and functions of the TV menu
Storage Mode
(optional)
Turn on mode
Installation
Automatic channel
search
Automatic channel
search
Network channel
search
Fine tune (analogue)

Initial Installation

Channel list

Use of the channel list

You can configure the channel list by moving, deleting, renaming and locking them to your liking.

Setting of parental control settings

To prevent certain programs from being watched, channels and menus can be locked through the parental control system.
To display lock menu option, enter the PIN code. By default, the set factory code is 0000. After entering the
appropriate PIN code, the Parental control settings menu will be displayed :
Menu lock : The Menu lock option enables or disables access to the menu.
Maturity lock: After installation, this option searches information related to parental programs and if this
parental level has been disabled, access to broadcast is not enabled.
Parental control lock: When the Parental lock option is selected, the television can only be controlled with
a remote control. In this case, the control panel buttons will not be active.
PIN code setting: Defines a new PIN code.
The default PIN code can change depending on the country selected.
If a PIN code is required to display a menu option, enter one of the following codes: 4725, 0000 or 1234.
Electronic Program Guide (EPG)
Some channels, not all, display information concerning the on-going program and the next one. Press the
button to get access to the EPG menu.
Through this menu, you will have access to the following information: Channels program, and summary of
selected program. Press the INFO button of the remote control, reserve or record a selected program.
Red button (Previous day) displays the previous day's programs.
Green button (Next day) : displays the next day's programs.
Yellow button (Zoom): Displays more information concerning the program.
Blue button (filter : Displays filter options.
Enables or disables the Demo mode..
This parameter configures preferences of the power on mode.
Always enabled : the television comes on when the main power on/off button is pressed.
Standby: the television always comes on in standby mode. / Last view : the television
comes on on the last channel/source selected.
If you wish to install or update new channels, you can use this menu. It displays
automatic setting options. Digital antenna : Searches and stores DVB channels.
Digital cable :Searches and stores DVB cable television channels Analogue :
Searches and stores analogue stations. Analogue and digital antenna : Search
and store DVB and analogue channels. Analogue and digital cable : Search and
store analogue and DVB stations..
Used to search or directly store a channel if the frequency is known.
Searches channels related to the transmission system.
You can use this option to fine-tune analogue channels. It is only available if
analogue channels are stored.
Deletes all television settings and takes you back to the first installation.
English - 72 -