Midland CARDO BT Rider FM Guide D'utilisation page 18

FM Broadcast Radio Functions
Your headset is equipped with a high-quality FM broadcast receiver.
This section explains how to enjoy the functions of the FM radio.
The BT Rider FM enables you to listen to FM radio while you are not
using the headset for a phone conversation.
While listening to the radio, you do not have to worry about missing
phone calls, as the headset automatically turns off the FM radio and
switches to Bluetooth headset operation when the phone rings or when
you decide to initiate a call. After the phone conversation has been
finished, the headset automatically returns to radio mode.
Turning the FM radio on
While no call is on the headset, press and hold the Radio button on
your headset for three seconds to turn on the radio. The radio turns
to the last radio station you were listening to. With some phones you
should wait a few seconds after ending a call before turning on the
radio.
Turning the FM radio off
While the radio is turned on, press and hold the Radio button for three
seconds to turn the radio off.
Switching preset memory for FM radio stations
There are 6 pre-set radio stations available on your BT Rider FM.
While the radio is on, tap the Radio button to toggle between saved
stations.
Searching for a new FM radio station
While the radio is on, press and hold the Volume Up or Volume Down
button for 3 seconds or until you hear the next station on your head-
set.
Pressing Volume Up will search upwards (higher frequency).
Pressing Volume Down will search downwards (lower frequency).
Once a station is found, searching stops and you can hear the station.
To save this station, refer to the following section.
To continue searching, press the Volume Up or Volume Down button
again for three seconds.
You may still continue to listen to the current unsaved station. Pressing
the radio button in this case will move to the next saved station.
Saving a broadcast radio station
The FM radio is equipped with a memory capacity of 6 stations.
Select the station you wish to replace by tapping the radio button until
you find the station you want to replace.
Search for a new station as described above.
Tap the Radio button within 20 seconds of finding the station to save
the current station.
If you don't save the station the radio will exit search mode without
saving the current station. You can still continue to listen to the current
unsaved station. Tapping the Radio button in this case will move to the
next saved station.
Radio Tone Signals
Function Signal
Changing between pre- 1 to 6 short beep tones, depending on
set memory locations memory location number 1 - 6
Radio functions – Summary
if you want to... ...do this
Turn on the radio During standby (not during phone calls!)
press and hold the radio button (the side
function key) for at least 3 seconds
Turn off the radio While radio is on, press and hold the radio
button for at least 3 seconds
Search for new radio While radio is on, press and hold the
station volume up or down button for at last 3
seconds
Save new radio station After station has been found, shortly press
the radio button to save the station
Increase radio volume While radio is on, press volume up
Decrease radio volume While radio is on, press volume down
7