ETA Systems PCI-065NA Guide De L'utilisateur page 3

ENGLISH
ESPAÑOL
FRANÇAIS
DEUTSCH
ITALIANO
electrician immediately to correct this wiring
error.
wiring errors will not illuminate the red LED
(amber for international models).
OPERATION
Once the power conditioner has been properly
installed and tested, the power switches
of the load may be turned ON. The power
conditioner circuit breaker can be used as a master
load switch (if the power conditioner is a model that is
not equipped with an external circuit breaker, the
distribution panel circuit breaker may be used to
energize the load).
INFORMATION SPECIFIC TO ALL
INTERNATIONAL MODELS
•
Models are for use in ordinary locations.
•
This power conditioner uses a basic type
insulation.
•
This power conditioner is Class 1 equipment.
•
This power conditioner is Type B equipment.
•
This power conditioner uses hazardous voltage.
•
The internal parts of this power conditioner are
not user accessible.
CAUTION: If the red LED (amber
for international models) is
continuously flashing, the wall
receptacle is not connected to the
system safety ground. Contact an
IMPORTANT: The red LED (amber
for international models) is not
intended to test general wiring
integrity. Hot-neutral reversal,
neutral-ground reversal, and/or
TECHNICAL AND SERVICE ASSISTANCE
Technical and service assistance is available in
North America between the hours of 8:00 a.m. and
5:00 p.m. Central Time by calling 800-321-6699.
CUSTOMER SERVICE
For service, obtain the model number, part
number, and serial number from the rear panel data
plate. Then contact ETA SYSTEMS via phone to
obtain a Return Material Authorization (RMA)
number. This number must be marked on the
shipping container and packing slip of the unit being
returned. The original shipping container should be
used if available. Additional charges will apply for
repair of damages caused by improper packing of
the returned unit. Unauthorized return shipments
will be refused. Units for repair must be shipped
prepaid to ETA SYSTEMS.
WARRANTY
ETA SYSTEMS warrants these power
conditioners (known hereafter as the "product") to be
free from defects in materials and workmanship for a
period of five years from the date of shipment. The
product will be repaired or (at ETA SYSTEMS's
option) replaced at no charge during this warranty
period. Product must be returned prepaid.
ETA SYSTEMS makes no warranties,
expressed or implied, of merchantability, fitness for a
particular purpose, performance, condition, capacity
or otherwise. The manufacturer is not liable for
incidental or consequential damages, monetary loss,
loss of sales or loss of business resulting from the
failure or malfunction of the product.
ENGLISH
ESPAÑOL
FRANÇAIS
DEUTSCH
ITALIANO