Programming Instructions - Camille Bauer Digem f 96x48CK Mode D'emploi

Enable Programming
!
Attention!
This work may only be carried out by a trained electrician. The pc board accessed during
this work is live.
The front frame, the front plate and the front
panel must be removed in order to enable
programming. Two coding switches are
located at the right of the display. Push the
upper switch to the right to enable program-
ming. If programming is not enabled, the
Loc message is displayed when program-
ming is initialized.

Programming Instructions

P
Instrument default program settings (normally disabled)
GOSSEN-METRAWATT
P
P
Time
P
15