Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Important Operation Notes
All actions and functions of the weather station are started on the touch screen by slightly touching (not
pressing) the related areas with the stylus, touch the flashing +, ON/OFF or – to make the corresponding
selection increase or decrease.
Note: the stylus can be found on the top rear of the console and can sometimes be stiff to remove the
first time.
Every time a programming step is activated by touching the related area on the Touch Screen a tone will
sound and the back light will come on for a few seconds. If no areas are pressed for 30 seconds the LCD
will automatically revert to the normal display mode (automatic time out).
Important Notes
System Start
Insert two LR6 (AA) size batteries into the transmitter. The LED located in the middle on the front of the
transmitter will illuminate for 4 seconds, then go off and begin to flash intermittently (approximately every
48 seconds). If the LED does not light up or stays on permanently make sure the batteries are inserted
the correct way.
Insert two LR6 (AA size) batteries into the Base Station. The console will illuminate for a few seconds
with all the display segments illuminated for checking. After this the Base Station will make an initial
measurement and start to register the transmitter (the Outdoor Reception Signal icon between the two
humidity readings will be turned on). Do not touch the Base Station before the outdoor data is received or
the outdoor sensor learning mode will be terminated. When the outdoor transmitter has been registered
the Base Station will automatically switch to the normal display mode from which all further settings can
be adjusted by the user.
Positioning
Once you have verified that all of the components of the weather station are working they can be
positioned in their permanent places. Before permanently mounting make sure that all the components
work properly together at their chosen mounting or standing locations. If there appear to be problems
with the 433 MHz radio transmission they can mostly be overcome by moving the mounting locations.
Note: The radio communication between the receiver and transmitter in an open field can reach a
distance of up to 100m providing that there are no interfering obstacles such as buildings, trees, vehicles,
high voltage lines, etc. Radio interferences such as PC screens, radios or TV sets, can in bad cases entirely
cut off radio communication. Please take this into consideration when choosing standing or mounting
locations.
Reconnecting Lost Signal
If no outdoor weather data is displayed as a result of loss of signal during set up, mounting, changing of
batteries in the transmitter or plugging or unplugging cables, simply remove the batteries from the Base
Station wait 2 minutes and reinsert. After this the Base Station will make an initial measurement and
start to register the transmitter (the Outdoor Reception Signal icon will be turned on). Do not touch the
Base Station before the outdoor data is received (this may take several minutes) or the outdoor sensor
learning mode will be terminated. When the outdoor transmitter has been registered the Base Station will
automatically switch to the normal display mode from which all further settings can be adjusted by the
user.
Note: When replacing batteries in the transmitter wait two minutes before re-inserting for a proper reset.
- 4 -
WS1093
Publicité
Table des Matières
