Aercus WS1093 Guide D'utilisation page 12

+ button or – button for 3 seconds to change the number faster. Touch the ON/OFF button to turn
the alarm on or off (the alarm icon will be turned on indicating the alarm function has been
activated).
4) Touch the rain section a fourth time to display the current maximum rain fall record. Touching the
rain section for 3 seconds will reset the maximum rain fall value to the current value.
5) Touch the rain section a fifth time to reset the rain fall value to 0. By pressing the rain section for 3
seconds the 1h, 24h, week, month and total rain will be reset to 0.
Pressure
1) Touch the PRESSURE section, the + and – button will be flashing. Touch the + button or – button to
shift the display between Absolute pressure and Relative pressure. Relative pressure value - if you
are significantly above sea level you will need to calibrate the air pressure reading to allow for your
altitude. To do so make sure you have selected Relative as above and change the pressure reading
to match with a local benchmark such as the local air pressure provided for your area on the Met
Service or Bureau of Meteorology websites. If Absolute pressure is selected, skip this step.
2) Touch the PRESSURE section again, the + and – button will be flashing. Touch the + button or –
button to shift the display unit between hPa, inHg and mmHg.
3) Touch the PRESSURE section a third time to set the Relative Pressure value. The + and – button will
be flashing, the rel icon will light up. Touch the + button or – button to change the value, hold the +
button or – button for 3 seconds to change the number faster.
4) Touch the PRESSURE section a fourth time to set the pressure high alarm function, the +, ON/OFF
and – button will be flashing, the HI AL icon will light up. Touch the + button or – button to change
the value, hold the + button or – button for 3 seconds to change the number faster. Touch the
ON/OFF button to turn the alarm on or off (the alarm icon will be turned on indicating the alarm
function has been activated).
5) Touch the PRESSURE section a fifth time to set the pressure low alarm function, the +, ON/OFF and –
button will be flashing, the LO AL icon will light up. Touch the + button or – button to change the
value, hold the + button or – button for 3 seconds to change the number faster. Touch the ON/OFF
button to turn the alarm on or off (the alarm icon will be turned on indicating the alarm function has
been activated).
6) Touch the PRESSURE section a sixth time to display the maximum pressure record, the recorded
maximum value will be flashing, the MAX icon will light up. By pressing the maximum value for 3
seconds the maximum value will be reset to the current reading.
7) Touch the PRESSURE section a seventh time to display the minimum pressure record, the recorded
minimum value will be flashing, the MIN icon will light up. By pressing the minimum value for 3
seconds the minimum value will be reset to the current reading.
Note: when absolute pressure is selected, step 3 will be skipped since absolute pressure is selected for
display.
- 12 -
WS1093