Hydrofarm PHANTOM DE Instructions page 9

Système d'éclairage à profil bas
Masquer les pouces Voir aussi pour PHANTOM DE:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TROUBLESHOOTING USING THE BALLAST'S STATUS LED
One rapid red flash
with long off interval
One rapid yellow flash
with long off interval
Two rapid red flashes
with medium-long
off interval
Two rapid yellow
flashes with medium-
long off interval
Three rapid red flashes
with brief off interval
Three rapid yellow
flashes with brief
off interval
One rapid red flash with
prolonged off interval
ERROR OR WARNING INDICATIONS
Too low voltage
Too low voltage occurred
in past
Too high voltage
Too high voltage occurred
in past
Too high temperature
Too high temperature
occurred in past
No signal from controller
(on PX)
Input voltage is too low
Ballast power drops to 50%
automatically
Input voltage was too low in
the past
Ballast power drops to 50%
automatically
Input voltage is too high
Input voltage was too high in
the past
Electronics temperature is too
high (max. 115°C/239°F)
Electronics temperature was
too high in the past (max.
115°C/239°F)
Fixture is connected to the mains
and set to PX but there is no
signal on the control input.
9
If input voltage accidently falls
below 108V, the ballast power will
automatically decrease to 50% of the
set power. Turn off the ballast and
replace with correct supply voltage.
If the voltage is a bit lower than 120V,
the LED will blink and the ballast
keeps running with set wattage.
See above, reset
Disconnect the ballast. Check input
voltage, check wiring and connection,
check neutral in 3 phase systems,
then reconnect the ballast. LED on
the ballast will blink but power will
not change.
See above, reset
There is temperature sensor in the
PCB of the ballast. If it senses the
internal ballast temperature reaches
1100C, the LED will start to blink. The
ballast power will decrease to 50%
of the set power automatically. Users
should turn off the ballast or cool
down the ballast.
See above, reset
If a controller is connected, search
for loose connections, defective
contacts or short-circuits. Re-connect
the controller to the ballast or verify
whether the controller is out of order.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Phdesk12lPhdeok12l

Table des Matières