Hydrofarm PHANTOM DE Instructions page 5

6. After sliding the socket ends closed, be certain that there is no gap between the edge
of the sliding section and the part it meets at the end of the slide path. Once lamp is
positioned correctly, slide the lamp holder inward toward the center of the bulb to secure
and lock the lamp in place as shown in PHOTOS G & H.
PHOTO G
PLEASE NOTE: Do not force the lamp holders closed. This could cause damage to both the
lamp and lamp holders. Do not handle lamp with bare hands. Always wear surgical or cloth
gloves whenever possible when handling lamp to minimize fingerprints and oils left on the
lamp. If the lamp needs cleaning after installation, use a soft dry cotton cloth to wipe off
fingerprints/skin oils.
IMPORTANT: Before you begin, make sure your light system is unplugged.
IN A GREENHOUSE SETTING
1. Simply place the hook-like curved end of the included truss hanger through the eye bolt
in the top rear part of the ballast housing with wire end facing inward toward reflector.
2. Then place the curved end of the other truss hanger through the hole in the nose of the
armature with wire end facing inward toward reflector and ballast. Hang the truss hangers
and system on the truss in the desired location.
LAMP INSTALLATION, continued
HANGING YOUR FIXTURE
1
PHOTO H
2
5
Continued >