Operating The Tool; Lubrication - Campbell Hausfeld SB303000 Mode D'emploi

Operating Instructions
General Safety
Information
(Continued)
G Always assume the tool contains
fasteners. Respect the tool as a
working implement; no horseplay.
Always keep others at a safe
distance from the work area in case
of accidental discharge of fasteners.
Do not point the tool toward
yourself or anyone whether it
contains fasteners or not. Accidental
triggering of the tool could result in
death or serious personal injury.
G Do not drive a
fastener on top of
other fasteners.
The fastener could
glance and cause
death or a serious
puncture wound.
G Do not operate
WARNING
!
or allow anyone
else to operate
the tool if any
warnings or
warning labels
are not legible. Warnings or warning
labels are located on the tool
magazine and body.
G Do not drop or throw the tool.
Dropping or throwing the tool can
result in damage that will make the
tool unusable or unsafe. If the tool
has been dropped or thrown,
examine the tool closely for bent,
cracked or broken parts and air
leaks. STOP and repair before using
or serious injury could occur.
a potentially hazardous situation
which, if not avoided, MAY result in
minor or moderate injury.
Recommended Hookup
Quick
Plug
G Do not make any modifications to the
tool without first obtaining written
approval from the manufacturer. Do
not use the tool if any shields or
guards are removed or altered. Do
not use the tool as a hammer.
Personal injury or tool
damage may occur.
G Avoid long extended periods of
work with the tool. Stop using the
tool if you feel pain in hands or
arms.
G Always check
that the Work
Contact Element
(WCE) is
operating
properly. A
fastener could
accidentally be
driven if the
WCE is not working properly.
Personal injury may occur (See
"Checking the Work Contact
Element" Section).
G Disconnect air supply and release
tension from the pusher before
attempting to clear jams because
fasteners can be ejected from the
front of the tool. Personal injury
may occur.
important information, that if not
followed, MAY cause damage to
equipment.
G Avoid using the tool when the
magazine is empty. Accelerated
Caution
wear on the tool may occur.
indicates
G Clean and check all air supply hoses
and fittings before connecting the
tool to an air supply. Replace any
damaged or worn hoses or fittings.
Tool performance or durability may
be reduced.
Quick
Coupler
Air
Hose
Notice
indi cates
Regulator
Oiler
Quick Plug
(Optional)
Quick
Coupler
(Optional)
3
Model SB303000
G Air compressors providing air to the
tool should follow the requirements
established by the American
National Standards Institute
Standard B19.3-1991; Safety
Standard for Compressors for
Process Industries. Contact your air
compressor manufacturer for
information.

Operating The Tool

LUBRICATION

This tool requires lubrication before
using the tool for the first time and
before each use. If an inline oiler is
used, manual lubrication through the
air inlet is not required on a daily basis.
can become damaged by excessive
lubrication. Proper lubrication is the
owner's responsibil- ity. Failure to
lubricate the tool properly will
dramatically shorten the life of the
tool and void the warranty.
1. Disconnect the
air supply from
the tool to add
lubricant.
2. Turn the tool so the
air inlet is facing up.
Place 4-5 drops of
30 W non-detergent
oil into air inlet. Do
not use detergent
oils, oil additives, or air tool oils. Air
tool oils contain solvents which will
damage the tool's internal
components.
Filter
www.chpower.com
The work
surface