FONESTAR MPZ-6480RGU Mode D'emploi page 3

/ M1: in player mode, a short press starts/pauses playback. In radio mode, a short press allows
j.-
the station stored in position M1 to be selected. And a long press stores the current station in
position M1, it displays the list of stored stations confirming that the action has been taken .
k.- / M2: in player mode, you can change the play
Play a song
Play all randomly
Play folder randomly
Play All
Play Folder
In radio mode, a short press allows the station stored in position M2 to be selected. And a long
press stores the current station in position M2, it displays the list of stored stations confirming that
the action has been taken.
USB/SD / M3: in player mode, select between the USB device or SD card. In radio mode, a short
l.-
press allows the station stored in position M3 to be selected. And a long press stores the current
station in position M3, it displays the list of stored stations confirming that the action has been
taken.
m.- / M4: in player mode, stops current playback. In radio mode, a short press allows the station
stored in position M4 to be selected. And a long press stores the current station in position M4,
it displays the list of stored stations confirming that the action has been taken . And in recording
mode, it stops recording.
2.- BASS: boosts/attenuates the bass frequencies of the input.
3.- TREBLE: boosts/attenuates the high frequencies of the input.
4.- VOL: volume control of the corresponding input. The VOL control of INPUT 1 controls the volume of
INPUT 1 and of the M-64 microphones; and that of INPUT 2 controls the volume of INPUT 2 input and
of the MZ-648 zone microphones.
5.- LED indicator light for activation of output zone.
6.- Output zone activation/deactivation button.
7.- VOL: output volume control.
8.- LED indicator light for activation of all zones.
9.- Button to activate/deactivate all zones.
10.- SIG - CLIP: LED output signal level indicators. It regulates the individual volume controls for the inputs
or the general (MASTER output volume, so that the level does not exceed the green LED indicators. The
red LED indicators indicate saturation or a distorted signal which could cause damage to the speakers
or the amplifier.
11.- ON: LED power indicator.
12.- STANDBY: LED standby indicator.
13.- : on/stanby switch for the amplifier.
14.- PROT: LED temperature or overload protection indicator.
15.- MASTER: control that regulates the general output volume for all the inputs.
16.- SIREN - ( / ): emergency SIREN.tone activation button An oscillating (
can be used.
17.- SIREN - VOL :volume control of the SIREN emergency tones.
18.- TEL: chime activation button for the priority TEL input
19.- TEL - RINGER: input chime volume control TEL - RINGER.
20.- TEL - PAGING: volume control of the corresponding TEL Input
mode:
- 3 -
EN
) or continuous ( ) tone