User Maintenance; Cleaning & Maintenance - Andis CNG-1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. Separate the dog's toes by placing your thumb between the pads and hold foot
securely. Push long hair away from the foot to avoid tangling or pulling. You can try
placing a nylon stocking over the foot and pushing nails through the nylon to allow
easy access to nails while keeping hair out of the way.
3. Support the toe and nail in one hand while using the nail grinder in the other hand.
This keeps vibrations to a minimum and is more comfortable for the dog.
4. To get a smooth edge, grind from the bottom of the nail up towards the tip.
5. Use a continuous side-to-side motion when grinding each nail; holding the tip in
one place too long can cause unevenness and over-grinding. Do not keep the
grinding wheel or stone against the nail for longer than three seconds at a
time.
6. IMPORTANT: Do not apply excessive force when grinding. Let the speed of the
grinder do the work. Do not apply pressure to the nail with the spinning grinding
wheel. Pressure causes the nail to get hot and will cause pain to the dog.
7. Keep the nail grinder away from the nail when first starting, or the grinder may
"grab" the nail and cause loss of control or injury to the dog.

USER MAINTENANCE

The internal mechanism of your nail grinder has been permanently lubricated at the
factory. Other than the recommended maintenance described in this manual, no other
maintenance should be performed, except by Andis Company or an Andis authorized
service station. To find an Andis authorized service station near you log on to
andis.com or contact our customer service department at 1-800-558-9441.
CLEANING & MAINTENANCE
• Turn the nail grinder OFF and remove the multi-function protective cap by twisting
counterclockwise to unlock and pulling straight up.
• Brush or blow off dust or other material from nail grinder after each use.
• Use a soft cloth to wipe off nail grinder.
• Replace grinding attachments when worn.
• Check cords and nail grinder for damage periodically.
Caution: Never handle your Andis nail grinder while you are operating a water
faucet, and never hold your nail grinder under a water faucet or in water. There is
danger of electrical shock and damage to the appliance. Andis Company will not
be responsible in case of injury due to this carelessness.
7

Publicité

Table des Matières
loading

Table des Matières