Andis CNG-1 Mode D'emploi page 3

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7. Do not touch the collet or attachments after use. These may
be hot and cause burns to the skin.
8. To disconnect, turn unit OFF, then remove plug from outlet.
9. Always wear safety glasses when using nail grinder. Do not
wear loose jewelry or clothing when in use. Keep long hair
pulled back out of work area.
10. Do not allow animal to lick or touch the nail grinder during use.
11. To prevent damage to the nail, do not hold the grinding
wheel or stone in one place on nail or apply excessive
pressure to the nail while grinding.
12. Make sure attachments are securely in place before use.
13. Do not leave nail grinder unattended when plugged in.
14. WARNING: During use, do not place or leave appliance
where it may be (1) damaged by an animal or (2) exposed to
the weather.
15. The battery must be removed from the appliance before it is
scrapped.
16. The appliance must be disconnected from the supply mains
when removing the battery.
17. The battery is to be disposed of safely.
18. Use only the charger supplied by the manufacturer to recharge.
SAVE THESE INSTRUCTIONS
THIS APPLIANCE IS INTENDED FOR PROFESSIONAL AND
HOUSEHOLD USE
OPERATING INSTRUCTIONS
Nail grinder must be pre-charged fully before using it for the first time. To start nail
grinder, push the POWER button; to stop, push the POWER button again. To turn on
TURBO speed (7,400 RPM), double click the POWER button; to return to NORMAL
speed (6,500 RPM), double click the POWER button (Figure A).
POWER SUPPLY
This unit is equipped with a universal AC/DC power adapter/battery charger (Figure A).
CHARGING NAIL GRINDER
The battery charger is intended for use with Andis CNG-1 nail grinder. Remove the
nail grinder and charger from the carton. Plug the charger into a 120V AC outlet, or
according to your local power standards (Figure A). Confirm the voltage available with
each overseas location before using the appliance. For connection to a 240V supply, use
an attachment plug adapter of the proper configuration for the power supply receptacle.
3

Publicité

Table des Matières
loading

Table des Matières