Aerus ORIGINS RO400 Manuel D'utilisation page 9

STEP SIX – CONNECT TUBING
CONNECT TUBING FROM MANIFOLD TO TANK.
1. Use remaining 3/8" white tubing set aside earlier and identify
length needed to connect tank outlet labeled "TANK" on (A) manifold to (E) tank.
2. Cut white tubing square with a utility knife.
3. Wet tubing end and insert into compression nut of tank connector fitting (connected
to tank) all the way to the tube stop inside the fitting body. If tubing does not enter
the nut easily, loosen the nut one turn and insert tubing all the way to the tube stop
in the fitting body.
4. Hand-tighten the nut and then tighten with wrench 1-2 turns.
5. Insert other end of white tubing into outlet of manifold labeled "TANK" approximately 5/8" until it stops.
AIR GAP FROM FAUCET TO RO ASSEMBLY.
1. Locate membrane drain port.
2. By pushing down on the white collar while pulling plug with other hand,
remove black plug from membrane filter drain port.
3. Identify 1/4" red tubing attached to faucet body.
4. Identify length necessary to connect to drain port.
5. With utility knife, cut the 1/4" red tubing squarely to desired length.
6. Insert restrictor into end of red tubing.
7. Insert red tubing into membrane drain filter approximately 5/8" until it stops.
8. Gently tug on red tubing to ensure it is firmly seated in fitting.
Notice: Do not remove restrictor.
CONNECT 3/8" TUBE FROM FAUCET TO DRAIN ADAPTOR.
1. Identify 3/8" red tubing attached
to faucet body.
2. Attach other end of tubing to collet on
sink drain connector.
3. Cut enough 3/8" red tubing to route in
as straight as possible without any
twists, kinks, loops or valleys.
4. Cut end of 3/8" red tubing squarely
with utility knife.
5. Insert into fitting approximately 1"
until it stops.
6. Gently tug on red tubing to ensure
it is firmly seated in fitting.
(Continued)
9
A
RO System
Manifold
Manifold
Tank Outlet
Membrane
Drain Port
E
Tank