Aerus ORIGINS RO400 Manuel D'utilisation page 8

STEP SIX – CONNECT TUBING
Notice: For servicing, tubing lengths should allow
for removal of assembly from mount screw
INSTALL TUBING FOR WATER SUPPLY LINE FROM
KITCHEN FAUCET ADAPTOR TO MANIFOLD INLET.
Notice: Do not bend or crimp tubing during this step.
1. Identify length of 1/4" white tubing necessary to
connect (A) manifold "INLET" to (F) kitchen faucet adaptor.
Allow sufficient tubing to prevent line kinking. Do not
discard remaining tubing.
2. With utility knife, cut the 1/4" white tubing
squarely to desired length.
3. With water, wet one end of tubing and push into the
kitchen faucet adaptor approximately 5/8" until it stops.
4. Wet other end of tubing and push into the manifold "INLET"
approximately 5/8" until it stops.
Notice: It is not necessary to remove tubing for routine maintenance and filter
exchanges, however, it may easily be disconnected if necessary. To disconnect,
turn off water supply to system and press in white collar around fitting while
pulling tubing out with other hand.
INSTALL OPTIONAL LEAK PROTECTOR – PART NUMBER 49451
1. Turn off the water supply to the filtration system at the cold water source valve.
2. The leak protector should be mounted flat in the lowest ground point
near the filtration system so in the event a leak occurs, the water will flow
in the direction of the valve.
3. Clean the designated installation area with rubbing alcohol.
4. Peel the red backing tape from the two mounting feet on the base of the
leak protector valve and press down firmly over the chosen install area.
You may also mount the valve using the screws included in the kit.
5. Cut the system's water supply tube to plumb in the valve. Connect the
F Kitchen Faucet
tube from the water source valve to the horizontal fitting on the leak
protector valve labeled "in" by pushing the tubing in firmly until fully seated.
6. Connect the tube leading from the filtration system to the vertical fitting on the
leak protector valve labeled "out" by pushing the tubing in firmly until fully seated.
7. Turn on the water supply to the filtration unit and check for leaks.
INSTALL TUBING FOR WATER SUPPLY LINE FROM MANIFOLD
OUTLET TO FAUCET.
1. Locate 3/8" white tubing already attached to faucet stem during Step 5 on page 6.
2. Identify length of tubing necessary to connect to manifold outlet labeled "FAUCET."
3. Cut tubing squarely with utility knife. Do not discard remaining tubing.
4. With water, wet one end of tubing and push into manifold outlet labeled "FAUCET"
approximately 5/8" until it stops.
F Kitchen Faucet
Adapter
s.
Adapter
Inlet Water
Tube Connection
8
Kitchen Faucet
F
Adapter
Inlet Water
Tube Connection
from
Filtration
System
A
Optional Leak Protector
V Leak Protector
A
RO System
Manifold
Manifold Outlet
for Faucet
from cold
water source
valve
RO System
Manifold
Manifold Outlet
for Faucet
T