Installing The Autoview 2020/2030 Switch - Avocent AUTOVIEW 2020 Guide D'installation Et D'utilisation

Chapter 2: Installation 7

Installing the AutoView 2020/2030 Switch

Plug the supplied power cord into the back of the switch and then into an appropriate power source.
Figure 2.1 illustrates one possible configuration for your AutoView 2020/2030 switch. See the
following detailed set of procedures to successfully install your switch.
CAUTION: To reduce the risk of electric shock or damage to your equipment -
- Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
- Plug the power cord into a grounded (earthed) outlet that is easily accessible at all times.
- Disconnect the power from the unit by unplugging the power cord from either the electrical outlet or the unit.