YEAZ NAPUA EXOTRACE Mode D'emploi page 13

REMOVING THE FIN
Unscrew the screw from the square nut. Slide the fin and then the square nut out of the
rail using the screw. Reattach the screw and square nut to the fin immediately.
DEFLATION
Gently press on the valve core needle to
slowly release pressure from the board.
If after about 10 seconds the air pressure
of the board has dropped a little, push the
valve needle completely down and turn it
clockwise to lock it in the „open" position.
When releasing the air, please make sure
that there is no sand or dirt around the
valve or getting inside.
CAUTION: Remove the valve cover only
to inflate/deflate the air. This prevents
accidental air leakage and the ingress of
any particles into the valve.
Now start to gently roll the board from the front side towards the valve to release the
remaining air from the board. Put the valve cap back on and close it tightly to prevent
dirt and moisture from entering. Now unfold the Stand Up Paddleboard again and start
rolling it in from the other side where the valve is located. This way the board folds
better and the fins are better protected at the same time. Place the foam pads provided
on the fixed fins for protection.
CLEANING
Clean and check the board and accessories (including paddles) after each use. Rinse
everything thoroughly to ensure that any residue or salt residue (when used in salt
water) is removed. Use mild soapy water. Do not use detergents or silicone based
cleaners. Make sure the paddleboard is completely dry before storing.
STORAGE
Please store your board in a clean and dry place, protected from major temperature
fluctuations and other harmful factors. You can roll up the board with deflated air or in
a slightly inflated state. Protect the board from rodents. Disassemble the paddle into its
individual components and store them separately to allow drying.
13