Power Supply; About The Disks - THOMSON RK300CDU Mode D'emploi

SAFETY REGULATIONS
INFoRmATIoN ABouT BATTERIES (not supplied)
• The appliance must be equipped with the appropriate batteries in order to function
properly.
• Only recommended batteries should be used.
• Polarity must be respected when inserting batteries.
• The batteries should be inserted in such a way as to avoid any short circuit.
• Do not mix used and new batteries.
• Do not mix alkaline, standard (carbon-zinc) and rechargeable (nickel-cadmium)
batteries.
• Do not recharge or try to open the batteries. Do not throw the batteries in the fire.
• Replace all batteries at the same time with identical batteries.
• Remove the batteries when unused for a long time.
• If the liquid contained in the batteries comes in contact with eyes or skin, wash the
area immediately and carefully with clear water and consult a doctor.
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
ATTENTIoN: Danger of explosion if batteries are not inserted correctly.

ABouT THE DISKS

Handling
Do not touch the playback side of disks.
Hold disks by the edges to avoid leaving fingerprints on the surface.
Any dust, fingerprints or scratches may cause a malfunction.
Never attach a label or sticky tape to the disk.
Storage
Put disks back in their case after playing them. Never expose disks to
direct sunlight or heat sources. Never leave disks inside a car parked in full
sunlight.
Cleaning
Use a clean soft lint-free cloth to clean the disk, working from the centre
outwards in a straight line. Do not use solvents such as petrol, thinners,
commercially available cleaners or antistatic sprays for vinyl disks.
EN 8
PORTABLE CD CASSETTE
RADIO RK300CDU
This appliance can operate on batteries or on mains power supply.
mains power supply
Verify that the appliance is switched off.
Connect the power cable to the AC socket on the back and then plug the other end to
the wall socket.
Note: If the power supply cable is connected, the batteries will not feed the appliance.
It is preferable to remove the batteries if the cable is connected to the power supply in
order to avoid their being damaged.
Battery power supply
• Lift the cover of the battery compartment on the back of the appliance by pressing
its flaps.
• Insert 8 LR14 (C) 1.5V batteries (not supplied) taking care to observe the indicated
polarity.
• Close the cover of the battery compartment.
Note: The power cable must be disconnected from the socket on the back of the
appliance or from the wall socket in order for the appliance to be fed by the batteries.
26

POWER SUPPLY

27
28
29