Tapping The Beer Keg; How To Operate - NOSTALGIA PRODUCTS Kegorator KRS2100 Serie Manuel D'instructions

TAPPING THE BEER KEG

(SINGLE VALVE-TYPE KEG)
Connect to Tap
Connect to the Connect to the Connect to Connect to
Tower Line
Beer Line Tube
Beer Line Tube CO2 Gas CO2 Gas
Connect to
Line Tube Line Tube CO2 Line
Black pull handle Black pull handle
Keg Coupler Keg Coupler
fig. 1
fig. 4
Follow these steps below to tap the Beer Keg.
1. Make sure the black pull handle of the Keg Coupler is in the open (up)
position before installing it on the keg (Fig. 1). Insert the Keg Coupler into
the locking neck of the Beer Keg and turn clockwise until it locks into
position (Fig. 2). This means that it is secured to the Beer Keg.
2. Make sure the Tap Tower is in the closed (handle pointing straight back) position before
connecting the Keg Coupler to the Beer Keg (Fig. 3). To secure the tank connection,
pull the Keg Coupler handle out and push down until it locks into position. Listen
for the "click" of the pull handle when it shifts into the final downward position
(Fig. 4). This will open the beer and CO 2 gas valves. The Keg is now tapped.
3. Carefully tilt the Keg and rest the edge on the Keg Base Board on the
bottom of the Interior Cabinet. Slide the Beer Keg slowly, ensuring
that it is properly located (Fig. 5) and carefully close the door.

HOW TO OPERATE

Follow the steps below to dispense beer.
1. Make sure that the KEGORATOR™ is plugged in properly to
a 120V, 60Hz, 15 Amps grounded AC outlet.
2. Place the Drip Tray under the beer faucet to avoid messes from excess beer.
3. Pour beer by pulling the Tap Handle towards you to dispense beer. Refer to
the section on Tapping the Beer Keg if the beer does not dispense.
Increase the pressure if the beer runs too slowly (see Setting the
4.
Double Regulator section). 8-10 PSI is recommended.
5. Hold the glass steady at a 45° angle. When it is ²
glass. Proper foam should be a tight creamy head and the collar
on an average glass should be ¾" to 1" high, ideally.
13
Beer Keg Neck Beer Keg Neck
fig. 2
Beer Keg
Beer Keg
Keg Keg Support
Keg Support
Base Board
fig. 5
full, straighten the
/ 3
fig. 3
Lift Upright Lift Upright