Installing The Casters; Tap Tower Installation - NOSTALGIA PRODUCTS Kegorator KRS2100 Serie Manuel D'instructions

INSTALLING THE CASTERS

NOTE: Each of the Front Casters include a locking mechanism to ensure the unit
does not roll on hard floors. The Front Casters should be fastened at the front
end of the unit, with the unlocked Rear Casters fastened on the rear end.
1. Empty the inside of the cabinet and lay the
unit down on it's side. To prevent dents or
scratches, we recommend placing a piece of
cardboard or cloth underneath the cabinet.
2. Place washers over Caster bolts, then
insert the Casters into the holes on the
bottom corners of the cabinet. Tighten
each Caster by turning the nut clockwise
with a wrench (not provided in the kit).
3. Once all four Casters have been tightened,
stand the cabinet in its upright position.

TAP TOWER INSTALLATION

1. Remove the packing tape on the Tap Tower.
2. Guide the (5) Tap Tower Washer up the tap tower hose and
over the notches located on the bottom of the Tap Tower.
Then feed the tap tower hose through the hole in the top of
the cabinet.
3. Align the notches at the bottom of the tower with the
hole in the top of the cabinet, then insert and twist the
tower clockwise to lock it into place (about a ¼ turn).
Tap Tower
Adapter
Beer Tower
Washer
Notches
8