Channel Select - Peavey Triple XXX 40 Mode D'emploi

®
Triple XXX 40 EFX
(23)

CHANNEL SELECT

This switch selects the channel (Ultra or Rhythm). The active channel LED illuminates to indicate the active
channel.
(24) EFX ADJUST
Pressing this control selects the effect. A yellow LED adjacent to the effect name will illuminate to indicate the
selected effect. Rotating this control clockwise changes the parameter of the active effect according to the
descriptions below. The surrounding LED ring indicates relative value of the parameter being adjusted.
EFX ADJ PARAMETERS
Tremolo:
Octaver:
Flanger:
Chorus:
EFX amps are built with factory settings loaded into the presets. To return to the factory settings, first turn the
power to OFF. Then‚ press and hold both the EFX ADJUST (24) and DELAY (26) controls while turning the
amp back on.
(25) VOLUME BOOST
This control adjusts the level of Volume Boost. The surrounding LED ring indicates level.
(26) DELAY
This control adjusts delay type, time, and volume. Three types of delay are available: SLAP (1 repeat), ECHO
(3–4 repeats), or INFINITE (5–6 repeats). The LEDs in each section of the control indicate which type is active
and level. Pressing the control twice sets the delay time to the interval between presses.
Rate increase
Wet/Dry mix
Rate increase
Rate increase/depth decrease
7
23 24 25 26
Funk wah: Sensitivity increase
Rotary Speaker: Rate increase
Phaser: Rate increase