Safety Regulations; Layout And Items Supplied - EINHELL CE-JS 8/1 Instructions D'origine

Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Danger!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.
Children are not allowed to use this equipment.
Children should be supervised so that they do not
play with the equipment. Children are not allowed
to carry out cleaning or maintenance. This equip-
ment is not allowed to be used by people with li-
mited physical, sensory or mental capacities or by
those with insuffi cient knowledge or experience
unless they are supervised or instructed by a per-
son who is responsible for them.
Key (Fig. 5)
Important! Read carefully before use!
Text on the equipment and jump start cable
Important! Read carefully before use!
1. Never press the "Boost" button before the car
battery has been connected.
2. Never connect the clamps together – risk of a
short-circuit and risk of injury.
3. Jump start only for 12 V cars; connect the red
clamp to the "+" and the black clamp to the "-"
battery pole.
4. „Correct" LED lights up green = Start the en-
gine within 30 seconds.
5. Red LED + acoustic warning signal = Battery
connected reverse polarity (see 3.)
6. „Correct" LED fl ashes green = Press the
„Boost" button and start the engine within 30
Anl_CE_JS_8_1_SPK9.indb 15 Anl_CE_JS_8_1_SPK9.indb 15
GB
seconds.
7. No LED, no acoustic warning signal = Check
the connector to the equipment, press the
„Boost" button and start the engine within 30
seconds.
Warning!
1. Keep the equipment out of reach of children!
2. Do not open the equipment - risk of injury!
3. If fewer than 3 LEDs are illuminated, the jump
start is not available.
4. If the engine fails to start within 5 seconds,
stop the jump start operation. Wait at least 1
minute before you repeat the operation.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1 Connection for jump start cable
2 Micro USB charging jack
3 5V/9V USB outlet
4 5V max. 2A USB outlet
5 LED lamp
6 On/Off button
7 LED battery capacity indicator
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made your purchase at
the latest within 5 working days after purchasing
the product and upon presentation of a valid bill
of purchase. Also, refer to the warranty table in
the service information at the end of the operating
instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
- 15 -
08.02.2021 08:43:17 08.02.2021 08:43:17