Functional Description; Optional Accessories - Makita DFJ201 Manuel D'instructions

Blouson ventilé sans fil
Masquer les pouces Voir aussi pour DFJ201:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 7
Installing or removing the fan unit to the
jacket (Fig. 4)
Attach the fan unit onto the jacket with closing the zipper.
And then fasten the snap button to secure it.
Attaching the battery holder (Fig. 5)
Connect the battery holder and the power cable of the
jacket.
You can hang the battery holder on your waist belt.

FUNCTIONAL DESCRIPTION

CAUTION:
• The fan jacket takes effect as intaking air which
temperature and humidity are lower than body surface.
The fan jacket may not take effect if circumstance air
temperature and humidity is higher than air in the
jacket temperature and humidity.
Switch action (Fig. 6)
To turn on the jacket, press and hold the power button (7).
The jacket starts with high air speed. Each time you tap
the power button, the air speed changes from high to
medium, medium to low, and low to high. The air speed
indicator (10) shows current air speed.
To turn off, press and hold the power button again.
Turbo button (Fig. 6)
By pressing turbo button (11), the jacket works in turbo
mode for quick cooling. The turbo mode lasts for a minute
and the air speed returns to normal.
Air flow control (Fig. 7, 8 & 9)
To maintain stable air flow, close the button at the neck of
the jacket.
You can control the air flowing inside the jacket by
fastening or opening the inner zippers.
When fastening the inner zippers (Fig. 8), the most of air
flows through neck opening with high air volume. When
opening the inner zippers (Fig. 9), the air flows through
neck and sleeves openings.
The sleeve of the jacket is detachable. Remove the
sleeve according to your work condition by unzipping.
Connecting USB devices (Fig. 10)
CAUTION:
• Connect only devices which are compatible with the
USB power supply port. Otherwise it may cause
malfunction to the battery holder.
The battery holder (with the battery) can work as an
external power supply for USB devices.
Open the cover and connect the USB cable (not included)
with the power supply port (12) of the battery holder. And
then connect the other end of the cable with the device.
The battery holder (with the battery) supplies DC5V, 2.1A
by one port, and 3.0A in total by two ports.
The USB cable can be placed inside the jacket for
convenience by using the hole of the pocket and cable
holder (Fig. 11).
NOTE:
• Before connecting USB device to the battery holder
(with the battery), always backup your data of USB
6
device. Otherwise your data may be lost by any
possibility.
• The charger may not supply power to some USB
devices.
• Wait for 10 seconds before charging another device
consecutively.
• When not using or after charging, remove the USB
cable and close the cover.
MAINTENANCE
CAUTION:
• Always be sure that the jacket is switched off and the
battery cartridge is removed before attempting to
perform inspection or maintenance.
If jacket does not switch on or any fault is found with a
fully charged battery cartridge, clean the terminals of
the battery holder and the battery cartridge. If jacket
still does not work properly, stop using the jacket and
contact our authorized service center.

OPTIONAL ACCESSORIES

CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Makita genuine battery and charger
NOTE:
• Some items in the list may be included in the package
as standard accessories. They may differ from country
to country.

Publicité

Table des Matières
loading

Table des Matières