Electrical Safety - Makita DFJ201 Manuel D'instructions

your local service center for
repair.
• Choose appropriate fan speed
in accordance with the usage
environment for continuous use.
• This appliance can be used by
children aged from 8 years and
above and persons with
reduced physical, sensory or
mental capabilities or lack of
experience and knowledge if
they have been given
supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved. Children
shall not play with the
appliance. Cleaning and user
maintenance shall not be made
by children without supervision.
• Before washing, detach the fan
unit, battery holder and remove
the battery cartridge. Wash the
jacket part only.
• Do not blow compressed air
towards the fan. Do not put
small stick into the fan unit.
Otherwise the fan and motor
may be damaged.
• Do not expose the jacket to rain
or wet conditions. Water
entering the jacket may
increase the risk of electric
shock.
• Do not abuse the cord. Never
use the cord for carrying, pulling
or unplugging the jacket. Keep
cord away from heat, oil, sharp
edges.
• Do not connect power source to
USB port. Otherwise there is
risk of fire. The USB port is only
intended for charging lower
voltage device. Always place
the cover onto the USB port
when not charging the lower
voltage device.
• Do not insert a nail, wire, etc.
into USB power supply port.
Otherwise a circuit short may
cause smoke and fire.
• Do not use the jacket while you
are under the influence of
drugs, alcohol or medication.
• Do not leave the fan jacket into
the high temperature place,
such as sun-heated car.
Otherwise plastic part may melt
and be damaged.
• For long time storage, remove
the battery holder and battery
cartridge from the jacket, and
remove the battery cartridge
from the battery holder.
• This appliance is not intended
for medical use in hospitals.

Electrical safety

1. Do not insert a nail, wire, etc.
into USB power supply port.
Otherwise a circuit short may
cause smoke and fire.
2. Do not connect power source
to USB port. Otherwise there
is risk of fire. The USB port is
only intended for charging
lower voltage device. Always
place the cover onto the USB
3