Imetec N5001 Instructions D'utilisation page 22

NOTE: When using the iron for the first time or whenever the filter is replaced, on pressing
the steam request button (13), a slight buzz will be heard and the iron will not generate
steam.
EN
This is absolutely normal and is caused by the anti-scale filter filling up. Keep the steam
request button (13) pressed for at least 1 minute, until the buzzing stops and the iron begins
to deliver steam.
NOTE: the electronic system modifies steam emission to safeguard the lifespan of the
product. The anti-scale filter (14) must be replaced as soon as possible.
Failure to replace the anti-scale filter (14) will invalidate the warranty.
CLEANING
WARNING! Make sure the plug is disconnected from the
socket and the soleplate has cooled down completely before
cleaning the iron.
Position the ON/OFF switch (5) to turn the product OFF.
Unplug the power supply cable with plug (7) from the socket.
Wait until the iron cools down completely.
Remove any starch deposits or residue on the surface of the base of the iron (12) with a damp cloth and
non-abrasive liquid detergent.
Clean plastic parts with a damp cloth.
Then wipe with a dry cloth.
STORAGE
Fold the mono-tube (10) in half, with the iron resting on its stand (9) [Fig. C].
Insert the folded mono-tube into the recess (4), sliding it inside the special clamp.
Slide the mono-tube (10) along the entire cable recess (4).
Insert the mono-tube (10) behind the second clamp [Fig. D].
WARNING! Risk of fire. Wait for the appliance to cool
completely before storing it.
19