Preparation; Use - Imetec N5001 Instructions D'utilisation

Open the filter hatch (2).
Make sure the filter (already inserted) is pushed right down into its seat.
Closes the filter hatch (2).
NOTE: When using the iron for the first time or whenever the filter is replaced, on pressing
the steam request button (13), a slight buzz will be heard and the iron will not generate
steam.
This is absolutely normal and is caused by the anti-scale filter filling up. Hold the steam
request button (13) pressed for about 1 minute, until the buzzing stops and the iron begins
to deliver steam.
Sort the laundry according to the international symbols shown on the label; if this is missing, sort
according to the type of material.
Start by ironing the garments that require the lowest temperature.
SETTING THE FILTER LIFESPAN
The filter lifespan can be set on the basis of the hardness of the water used for ironing.
Turn the ON/OFF switch (5) to ON. Indicator light 8I (corresponding to the cotton temperature) will switch
on, and the iron will begin to heat up. In this phase, you can set the duration of the filters.
If the water used is fairly hard (i.e. from 9°f to 18°f), no modification is needed as the filter duration is
already set on «Set filter 1».
If the water is soft (i.e. up to 8°f), set the duration on «Set filter 2» as follows:
1. Press button 8B for at least 2 seconds.
2. The iron will emit a sound and the Set Filter 1 indicator light (8A) will switch on. At the same time, the
indicator light for the selected temperature (8E, 8F, 8I or 8H) will switch off.
3. To alter the setting of the filters, briefly press button 8B. The «Set Filter 2» indicator light (8C) will now
come on.
To confirm, keep button 8B pressed for at least 1 second. The iron will emit a sound and the «Set Filter
2» indicator light (8C) will switch off. This means the duration setting has been correctly selected. The
previously selected temperature indicator light will now automatically come back on again, flashing.
Wait for the light to stop flashing before using the iron.
WARNING! This appliance is not to be used if it has been
dropped, if there are visible signs of damage or if it is leaking
water.
WARNING! DO NOT pour diluting agents, scented liquids or
descaling agents into the reservoir as the use of these
substances can damage the product.

PREPARATION

USE

EN
16