Assembly Instructions - Kobalt SGY-AIR131TZ Mode D'emploi

ASSEMBLY INSTRUCTIONS

1. Remove the air inlet protective cap from the
air inlet (G). (See Figure 1)
2. Mount a male plug (not included) by hand into
the air inlet (G). (See Figure 2)
NOTE Use thread sealant tape (not included) on
the male plug and tighten it with a wrench (not
included) for airtight connection. Do not
overtighten.
3. Place 2 - 3 drops of air tool oil (not included)
into the male plug before each use.
(See Figure 3)
1
2
3
9