Operating Instructions - Kobalt SGY-AIR131TZ Mode D'emploi

ASSEMBLY INSTRUCTIONS
4. Mount a 3/8 in. to 1/2 in. adapter (not provided)
onto the anvil (B) if necessary, and then choose
the correct impact socket (not provided) as
needed and mount it onto the adapter.
(See Figure 4)
Only use impact sockets that have an RPM
rating equal to or greater than the tool itself.
5. Connect air supply hose to the male plug. Set
the working pressure at 90 PSI for best tool
performance. (See Figure 5)
NOTE Working pressure refers to the air line
pressure set to tool when tool is under working
conditions.

OPERATING INSTRUCTIONS

1. How to install/tighten threaded fasteners.
Turn the F/R knob (C) counterclockwise to "F"
position. Press the trigger (D). The tool anvil
(B) runs clockwise. (See Figure 1)
WA R N I N G
4
5
1
10