Brush Roller; Changing The Filter Bag - Windsor AXCESS Serie Mode D'emploi

Brush Roller

To remove the brush roller, press the button and turn
the bearing downward.
Turn the brush slightly to the right and pull it out.
We recommend to regularly remove threads and hair,
which have been wound around the brush roller.
Filters
When the orange bag full indicator is showing, airflow
is reduced. This could be because the filter bag is full,
the filters are clogged or there may be a blockage.

Changing The Filter Bag

1. Remove the filter bag by opening the latch on the
side of the bag housing.
2. Close the filter bag with the sealing cap and lift it
out.
The procedure to replace the bag is illustrated on the
front of each bag.
NOTE: You cannot close the bag housing if the bag
is fitted incorrectly.
Changing Filters
Motor Protection Filter
NOTE: This filter can only be accessed by removing
the filter bag.
1. Lift the motor protection filter up by the bracket.
2. Replace with new.
NOTE: Make sure filter fits in position tightly.
3. Put filter bag back in place.
The filter should be changed when it is dirty, at
minimum. No later then replacing 20 filter bags.
Exhaust Filter
NOTE: Recommended to replace every time you
replace the Motor Protection Filter.
1. Carefully remove the filter retaining rings and put
them to the side.
2. Pull the enforcement strips of the filter out of the
housing slot.
3. Remove the filter from the housing.
4. Replace with new in reverse order.
Be sure the filter is fitted correctly in the housing slot
and retaining rings are installed correctly.
NOTE: If the filter is NOT installed correctly it will be
ineffective.
Use ONLY replacement parts procured from the
manufacturer to ensure effectiveness and safety.
DO NOT wash any filters.
86404610 Axcess
Maintenance
13