Noise Emission; Contents Of Delivery; Machine Description; Transport And Start Up - Jet Tools GHB-1330 Mode D'emploi

GHB-1330/ GHB-1340A:
Spindle taper
Spindle nose DIN 55029
(Camlock)
Hole through spindle
Spindle speeds...8
Tailstock ram travel
Tailstock quill diameter
Tailstock taper
Cross slide travel
Top slide travel
Tool size max
Lead screw pitch
Longitudinal feeds..36 0,04–0,8mm/r
Cross feeds...36 0,01–0,2mm/r
Metric threads...23
Inch threads...32
Mains 400V ~3L/PE 50Hz
Output power 1,5 kW (2 HP) S1
Reference current
Extension cord (H07RN-F):
Installation fuse protection

4.2 Noise emission

Acoustic pressure level
(according to EN ISO 11202):
Idling at maximum speed
LpA 78,4 dB(A)
The specified values are emission
levels and are not necessarily to be
seen as safe operating levels.
As workplace conditions vary, this
information is intended to allow the
user to make a better estimation of the
hazards and risks involved only.
4.3 Content of delivery
GHB-1330:
Machine cabinet stand
Chip tray
Splash guard
160mm 3-jaw universal chuck
300mm faceplate
Four way tool post
Steady rest
Follow rest
Set of change gears
2 pcs. MT3 fixed centres
MT3/MT5 centre sleeve
Threading dial
Operating tools in tool box
Oil can
Lifting hook
Operating manual
Spare parts list.
GHB-1340A:
MT-5 Machine cabinet stand
D1-4 Chip tray
Splash guard
∅38 mm
160mm 3-jaw universal chuck
200mm 4-jaw independent chuck
70-2000 rpm
300mm faceplate
95mm
Four way tool post
32mm
Steady rest
MT-3
Follow rest
Set of change gears
160mm
2 pcs. MT3 fixed centres
68mm
MT3/MT5 centre sleeve
16 x 16 mm
Threading dial
4mm
Operating tools in tool box
Oil can
Lifting hook
0,45–10mm/r
Operating manual
3,5 – 80 TPI
Spare parts list.
4 A
4x1,5²
16A
A....Lathe bed
B....Carriage
C....Top slide
D....Cross slide
E....Four-way tool post
F....Headstock
A....Apron
B....Tailstock
C....Lead screw
D....Feed rod
E....Gear box
F....Steady rest
G....Follow rest

4.4 Machine description

Fig 1
Fig 2
5
Fig 3
H....Pulley cover
I......3-axis digital readout (option)
J.....Chuck guard
K....Tool post guard

5. Transport and start up

5.1 Transport and installation

The machine will be delivered in a
closed crate.
For transport use a forklift or hand
trolley. Make sure the machine does
not tip or fall off during transport.
The machine is designed to operate in
closed rooms and can be bolted to the
floor.

5.2 Assembly

If you notice transport damage while
unpacking, notify your supplier
immediately. Do not operate the
machine!
Dispose of the packing in an
environmentally friendly manner.
Clean all rust protected surfaces with
petroleum, diesel oil or a mild solvent.
Unbolt the lathe from the shipping
crate bottom.
Move the carriage and tailstock to the
tailstock end of the bed.
Assemble lifting hook (parts fastened
to the crate bottom) to lift the lathe
(see Fig 4)
Fig 4