Maintenance; Grease Filter; Carbon Filter; Cleaning - Electrolux EFG 732 X Manuel D'utilisation

Maintenance

Before performing any maintenance
operation, disconnect the hood from
the electricity.

Grease filter

This serves to hold the grease particles in suspen-
sion. The metal filter should be washed every
month with warm soapy water or, if possible, in the
dishwasher (60°C).
To remove the metal grease filter, fold the grips
upwards and press the locking slide in at the side
(Fig. 5). Leave to dry before refitting it.
(Only EFG 732): remove central plastic strip Z
to free the two filter panels (Fig. 11).
Clean the panels support as well.

Carbon filter

This filter dissolves cooking odours.
It should be changed every 6-8 months in normal
use. The carbon filter must never be washed.
To exchange the carbon filter:
Remove the grease filter
Take the old carbon filter out by pressing in the
two red lugs (2-Fig. 9) and pull it out forwards.
Fit the new carbon filter first on the lamp side of
the hood (1-Fig. 9), press the two red lugs of the
filter and clip the filter upwards into the hood.
Refit the grease filter.
Attention
Failure to observe the rules for cleaning the appli-
ance and changing and cleaning the filters may
cause fires. Therefore, we recommend observing
these instructions.

Cleaning

To clean the outside of the hood use a cloth mois-
tened with denatured alcohol or neutral liquid
detergents. Never use products containing
abrasives.

Changing the lighting elements

Disconnect the hood from the electricity.
Open the light cover by turning the latches
counterclockwise 1 (Fig. 12 and 13).
Pull the old lamp out of the holder and replace it
with a new of same rating
EFG 732 X has 2 PL lamps of 9 W (Fig. 12).
EFG 532 X has 1 PL lamp of 11 W (Fig. 13).
Fig. 11
Fig. 12
Fig. 13
48
Z