Installation; Unpacking; Placement; Electrical Connection - Electrolux EFG 732 X Manuel D'utilisation

Installation

Unpacking

Check that the cooker hood has no damages.
Transportation damages should immediately be
reported to the one responsible for the transport
Damages, faults and eventually missing details
should immediately be reported to the seller.
Take care of the packing material so that small
children cannot play with it.

Placement

The hood is to be mounted in a wall cupboard.
When installed, the hood must be not less than 65
cm. above electric burners or 75 cm. above gas or
mixed-fuel burners. (Fig. 3).

Electrical connection

The hood has a power cord with moulded plug
with earth connection to be connected to a wall
outlet of 230 V.
The power cord length is 1,2 m.

Mounting of hood

Fit the 120 mm air outlet connector with no
return valve (bayonet connection, one half turn
to the right) (Fig. 4).
Remove the metal grease filter grill. Fold the
grips upwards and press the locking slide in at
the side(Fig. 5).
Take the housing cover off by pressing the two
spring clips (Fig. 6).
Fit the extractor hood into the opening in the
cabinet and press it upwards in such a way that
two springs (1-Fig. 7) on the side notch into
place above the supporting plate.
Tighten screws (2-Fig. 7).
The housing can be further fastened to the
cabinet with the four 2,9 x 16 mm screws.
Replace the housing cover and clip in the metal
grease filters.
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
46
Min
Min
75 cm
65 cm