Safety Precautions; System Characteristics - golmar RD-V2PLUS Manuel D'installation

42
O Install or modify the equipment without the power connected.
O The installation and handling of these equipments must be performed by authorised personnel.
O The entire installation must be at least 40 cm. away from any other installation.
O Do not use excessive force when tightening the connector screws.
O Install the unit in a dry and protected place without risk of drip or water projections.
O Avoid to place it near to heating sources, dusty locations, humid or smoky enviroments.
O Do not block ventilation holes of the unit so that air can circulate freely.
O To avoid damage, the repeater has to be firmly fixed.
O
Digital repeater for V2Plus system a
w
It increases the distance in 200 meters more.
w
In daisy chain installations (without distributors), it increases 16 monitors/telephones in a maximum
distance of 150 meters between the repeater and the last monitor/telephone and between
monitors/telephones of the different apartments (connected to repeater).
w
It increases 32 monitors/telephones in a maximum distance of 150 meters between the repeater
and the last monitor/telephone and between monitors/telephones of the different apartments
(connected to repeater).
O In installations with 2 repeaters in daisy chain and 1 multiplexer the distances will be:
wThe repeater will increase the distance in 150 meters more.
w
In daisy chain installations (without distributors), it increases 16 monitors/telephones in a maximum
distance of 100 meters between the repeater and the last monitor/telephone and between
monitors/telephones of the different apartments (connected to repeater).
wIt increases 32 monitors/telephones in a maximum distance of 100 meters between the repeater
and the last monitor/telephone and between monitors/telephones of the different apartments
(connected to repeater).
O Up to 2 digital repeaters connected in daisy chain.
O Maximum distance between the power supply and digital repeater: 3 m., with a wire section of 1,5 mm.
O Autodiagnostic leds showing the Bus status (in the riser where repeater is installed) and the power
supply status of the repeater.
O The Tekna V2Plus Color monitor must be the version V.02 or later, for its compatibility with the
repeater.
O
IMPORTANT: In the output of a
O Use Golmar RAP-2150 cable in the V2Plus system.

SAFETY PRECAUTIONS

SYSTEM CHARACTERISTICS

llows one of these functions at once
distributor cannot be connected another distributor
:
.
2