Suntec Wellness KLIMATRONIC CoolBreeze 4000 SV-RC Mode D'emploi page 10

Mounting the fan head
1. Parts identification of the fan head
1. motor
2. rear guard
3. guard lock nut
4. blade
5. blade cap
6. front guard
7. screw
2. Mounting the rear guard
Mount the rear guard on the Motor and secure it with the Guard
lock nut.
3. Mounting the blade
insert the blade onto the motor shaft. Tighten the blade with
the blade cap.
4. Mounting the front guard
Fix the front grille in place by attaching the
hook on the top of the front protective grille above the rear
protective grille. Now connect the two grilles by pressing them
together laterally so that the two protective grilles are attached to
the external plastic ring.
Close the clamp and secure it with a screw.
How to use
Speed control
The fan speed can be set as follows:
Function of the pushbuttons
To switch on the unit, simply press the push button "On/Speed". Please press the button several times to switch
between the "Low, Medium, High" speeds. Please press the "Mode" button to switch between normal and sleep
mode. Press „Off" to turn off the unit.
Oscillation
Push down the oscillation knob and the Fan will oscillate, pull up the knob, the fan will not oscillate.
Tilting adjustment
Always switch the fan off before Making a tilt adjustment, the air Flow can be adjusted upward or Downward by
simply moving the guard up or down.
Height adjustment
Loosen the height adjustment knob, then adjust the pipe to the desired. Height and the tighten the adjustment
knob.
Timer
The fan is equipped with a 7.5 hour timer. Press the TIMER button to start up the timer. Each time the button is
pressed, the time is increased by 0.5 hours. As soon as the timer is set, the function light lights up.
Remote control
The model CoolBreeze 4000 SV-RC is equipped with a remote control.
Please use 2 x AAA battery (not included).
Technical information
Operating voltage:
Power consumption
CoolBreeze 4000 SV-RC
220-240V~ / 50Hz
50W